This is a very small, extremely light weight battery based on the new Polymer Lithium Ion chemistry. This is the highest energy density currently in production. Each cells outputs a nominal 3.7V at 500mAh! Comes terminated with a standard 2-pin JST-PH connector - 2mm spacing between pins. These batteries require special charging. Do not attempt to charge these with anything but a specialized Lithium Polymer charger. Battery includes built-in protection against over voltage, over current, and minimum voltage. Note: Be careful with the JST connectors. They can stick in pretty good and tugging on them can damage the connector. Check this tutorial for an easy way to remove them safely.
•Bateria: LiPo. •Voltaje de carga: 3.7V.
•Capacidad de descarga: 30 a 60C
•Descarga continua: 25C Aplicación
•Dimensiones (mm) : Largo 58(±3) * Alto 18.5(±1) * Ancho 6.5(±1)
• Peso de la batería (g): 15(±4).
OJO!!!, PRODUCTO DELICADO Y DE MANEJO ESPECIALIZADO, ESTOS PRODUCTOS VIENEN CHECADOS Y VERIFICADOS DESDE EL PROVEEDOR, SE SOBREENTIENDE QUE LA PERSONA QUE LO COMPRA TIENE LOS CONOCIMIENTOS Y EXPERIENCIA SUFICIENTE PARA EL MANEJO DE LA MISMA. NO SE MANEJA GARANTÍA.POR FAVOR LEA EL INSTRUCTIVO CUIDADOSAMENTE.PESO: 130g. His high discharge LiPo is a great way to power any R/C, robotic, or portable project. This is an excellent choice for anything that requires a small battery with a lot of punch. The voltage is low enough not to tax your regulating circuits, and the discharge rate is high enough to accommodate a lot of electronics and motors. We customized it by using an Arduino Compatible Power Jack to make easier to be integrated into any Arduino Project. It is also the best selection for Arduino power robots. SPECIFICATION:
7.4V 2-cell pack
1800mAh of charge
20C continuous discharge rate
8AWG bare discharge leads
1000 chargin cycle
Arduino Compatible DC2.1 Power Jack
Su display te indica el proceso de carga de cada batería
Si dejas las pilas conectadas no se dañarán gracias a su circuito contra sobrecarga
Compatible con pilas de níquel-metal y níquel-cadmio
Tiene clavija abatible y tamaño compacto para guardarlo fácil
If you need to charge LiPo batteries, this simple charger will do just that, and do it fast! The Lithium Battery Charger can charge 3.7V LiPo battery at a rate of 500mA per hour. It is designed to charge single-cell Li-Ion or Li-Polymer batteries. Check the datasheet below to see if it will work with your battery. The board incorporates a charging circuit, status LED, connector for your battery (JST-type used in the batteries we carry), and a micro-USB connector. Four small mounting holes allows this charger to be easily embedded into a project.