DB9 CARCAZA PARA CONECTORES DB9 MACHO Y HEMBRA, FABRICADA EN PLASTICO, COLOR GRIS.

This product is a carrier board or breakout board for Allegro’s A4988 DMOS Microstepping Driver with Translator and Overcurrent Protection; we therefore recommend careful reading of the A4988 datasheet (380k pdf) before using this product. This stepper motor driver lets you control one bipolar stepper motor at up to 2 A output current per coil (see the Power Dissipation Considerations section below for more information). Here are some of the driver’s key features: Simple step and direction control interface Five different step resolutions: full-step, half-step, quarter-step, eighth-step, and sixteenth-step Adjustable current control lets you set the maximum current output with a potentiometer, which lets you use voltages above your stepper motor’s rated voltage to achieve higher step rates Intelligent chopping control that automatically selects the correct current decay mode (fast decay or slow decay) Over-temperature thermal shutdown, under-voltage lockout, and crossover-current protection Short-to-ground and shorted-load protection

RESISTENCIA DE CARBÓN, 18K Ohms 1/2Watt. TAMBIÉN MANEJAMOS OTROS VALORES Y POTENCIAS. VIENEN EN TIRAS DE 5 PIEZAS.

REGULADOR DE BAJA CAIDA AJUSTABLE, TAMBIEN CONTAMOS CON EL LM2576HVT-ADJ

DIODO SCHOTTKY 3A/40V

TRANSISTOR PNP 140V/6A, ENCAPSULADO TO-220

TRANSISTOR NPN 45V/.8A PEND. INFO ADICIONAL

CAPACITOR 1800uF 10V TENEMOS OTROS VALORES Y MODELOS

FUSIBLE PARA DISCO DURO, IMPRESORAS, PLOTTERS, ETC... 5A/250V. TAMBIEN MANEJAMOS OTROS AMPERAJES

PLACA FENOLICA PARA CIRCUITOS IMPRESOS 10X15CM, BAQUELITA. TAMBIEN MANEJAMOS LAS SIG. MEDIDAS: 5X5, 10X10, 10X20 Y 20X20CM, ASI COMO PLACAS DE DOBLE CARA Y PERFORADAS.

TRANSISTOR TIPO PNP, 60Volts 1 Ampere

RESISTENCIA 1K Ohm 5Watts. TAMBIEN MANEJAMOS EN OTROS WATTAJES

Este modulo es muy fácil de utilizar, ya está listo para grabar audios de hasta 10 segundos, solo tienes que mantener presionado el botón REC de color rojo y soltarlo cuando desees que finalice la grabación, El siguiente botón PLAY reproducirá el mensaje grabado en su totalidad, mientras que el botón PLAY solo reproduce el mensaje cuando se mantiene presionado. Este modulo se puede alimentar con una pila de 3V CR2032, cr2025, o 2 pilas AA, AAA. es ideal para implementarse en muñequitos de peluche. With looping, jog playback, single-pass play function Available single-chip control This module can directly drive a small speaker 8 ohm 0.5W Working voltage: DC 3 to 5V Loudspeaker: 8Ω, 0.5W Power supply: 3 - 5V Size: 3.7 x 4.1cm / 1.45 x 1.61 inch

This ADXL345 is dynamic acceleration resulting from motion or shock, also well suited to measures the static acceleration of gravity in tilt-sensing applications.Its high resolution (4 mg/LSB) enables measurement of inclination changes less than 1.0°. The new version adds 2 standoff holes as well as an extra decoupling capacitor. This ADXL345 is a small, thin, low power, 3-axis accelerometer with high resolution (13-bit) measurement at up to ±16 g. Digital output data is formatted as 16-bit twos complement and is accessible through either a SPI (3- or 4-wire) or I2C digital interface.

PRODUCTO DESCONTINUADO!!! (0 PIEZAS DISPONIBLES) Lattice Semiconductor LCMXO2-7000HE-B-EVN MachXO2 Breakout Board is a simple, low-cost board featuring the MachXO2-7000HE PLD. The 700HE PLD provides more than 5 times the logic capacity in a higher-performance FPGA using the same package/footprint as the previous MachXO2 device, the MachXO2-1200ZE.

This board is a simple carrier for Allegro’s ±5A ACS714 Hall effect-based linear current sensor. This version accepts a bidirectional current input with a magnitude up to 5 A. The output is an analog voltage (185 mV/A) centered at 2.5 V with a typical error of less than 1.5%.